Duratrax, TORQ .21 ENGINE WITH RECOIL

TECH NOTES
      This is the Duratrax Torq .21 RC Car Engine with a Pull Starter.

FEATURES: Black Machined Aluminum 8 Horizontal Fin Heatsink Cylinder Head
          Finned Crankcase to Help Dissipate Heat Along the Top of Crankcase
            and Strengthen the Area Behind the Front Bearing
          1-Piece Crankcase with TORQ 3.5 Written on Both Left and Right Sides
          Rear Exhaust
          Dual Heavy-Duty Ball Bearing Supported Crankshaft
          Black Bolt-On Pull-Starter
          True ABC Cylinder and Piston Assembly
          Efficient Slide Valve Carb w/ Adjustable High and Low Needles
          Double Rubber O-Ring Sealed Carburetor Neck
          Heavy-Duty Con Rod (connecting rod) w/ Oil Feed Hole
          90-Day Warranty

INCLUDES: One Assembled Engine with Pull-Start & Pre-Installed Carburetor.
          One Drive Washer (DTXG0565)
          One Drive Washer Collet (DTXG0566)

SPECS:    Displacement:        3.46cc
          Bore:                16.6mm
          Stroke:              16mm
          Practical RPM Range: 3,500 - 31,000
          Crankshaft thread:                             6mm
          Center to center, left and right mount holes: 38mm
          Center to center, front and back mount holes: 16mm
          Back of engine (including pull start)
            to front of drive washer:                   87mm
          Back of engine to end of Crankshaft:         106mm
          Height:                                      101mm

REQUIRES: Fuel with at least 18% lubricant and 10%-20% nitromethane
          Muffler (Exhaust System) Depending on Vehicle
          Glow Starter
          Fuel Filter   (KYOE8076)
          Glow Plug #A5 (OSMG2693)
COMMENTS: Use the instructions provided with the kit for running of engine.
          High Speed Needle: 2-1/2 to 3 turns counter clockwise from closed.
          Low Speed Needle: Flush with outer housing.
          Throttle Stop Screw: approx. 1.5mm (1/32" to 1/16") from fully closed
          The HGIC9300 yank eliminator fits onto this engine, but the modeler
            is on their own to make it work properly.

                                                             
ACCESSORIES
 THIS IS A REAR EXHAUST .21 BUGGY ENGINE.  STARTING EQUIPMENT IS IN BUGGY ACG.
INCLUDES: PRE-INSTALLED CARBURETOR, DRIVE WASHER AND COLLET
REQUIRES: FUEL W/ 10%-20% NITROMETHANE AND 18% MINIMUM LUBRICANT, FUEL FILTER,
          TUNED PIPE AND HEADER (DEPENDS ON CAR KIT).