DUM1211    Dauntless Kit 

TECH NOTES

This is the Dumas Dauntless 49.5" Commuter Boat.
Dumas states that you Can Make this Boat Either Electric or Gas Powered.

FEATURES: Plywood construction
Die-cut pieces
Highly detailed deck hardware
Molded plastic pieces
3/4"-1" scale appearance
Gas or electric R/C powered (up to the modeler)

INCLUDES: All the wood parts required for assembly, plastic parts, decking
hardware, brass rods, fully detailed instructions, and plans.

REQUIRES: 14x50 flat building board, soldering iron, hobby knife, hobby saw,
hammer, drafting triangle, drills, 2 ounce fiberglass cloth, epoxy,
CA, polyester finishing resin, micro balloons, sandpaper, paints,
Dumas hardware kit #2332. SEE COMMENTS FOR POWER PLANTS AND PROPS.

SPECS:    LENGTH: 49-1/2"   Width 14"   Scale 3/4"-1"

COMMENTS:      Power                        Props              Speed
Single 6V or 12V motor         3114-3115           3-4 mph
per shaft direct drive       (L & RH 3 bld)
2 6V or 12V motors             3112-3113           5-7 mph
per shaft (no reduction)      (L & RH 3 bld)
.19-.25 glow engine            3105-2 bld          9-15 mph
3117-3 bld
.29-.40 glow engine            3115-1-3/4" 3 bld   15-20 mph
3113-2" 3 bld

ACCESSORIES

NO INSTRUCTIONS JUST DETAILED PLANS. KIT IS FOR EXPERTS. ALL PARTS ARE DIE CUT.
LOTS OF DETAILING IS REQUIRED. KIT MAY BE MODIFIED FOR GAS, GAS ENGINES SHOULD
ROTATE IN OPPOSITE DIRECTIONS. (NONE AVAILABLE FROM TOWER)
IF PAINT IS DESIRED, USE URETHANE OR EPOXY PAINTS.

|  Homepage  |  R/c Boats  |  Accessories  |  Cables  |  Chargers  |  Speed Controls  |  Engines  |  Props  |  Radio's  |  Search  |