FJIG0124     BT-24M 23.9cc/1.5CI Gas Marine 

TECH NOTES

This is the BT-24 Water-Cooled Marine Gasoline Engine from Fuji Imvac.

FEATURES: Designed with the output shaft and outdrive compatible with Zenoah
engines for a no-mod upgrade in power and performance for
R/C speed boats
V-Start recoil starter system for easy starting
Water cooling helps the chrome plated cylinder head resist heat
Automatic Timing Module (ATM) provides easy ignition by starting with
low timing to eliminate kickbacks, proportionally increasing timing
as rpm increases, for more power
Dual ball bearings on both the crankshaft and con rod
Direct linkage throttle setup provides faster, more accurate response
than a bell crank system
Walbro carburetor features easy-to-use butterfly choke valve and fuel
primer for quicker fuel delivery
THREE YEAR warranty

INCLUDES: One BT-24 Water-Cooled Marine Gasoline Engine from Fuji-Imvac with
Champion RCJ8Y resistor spark plug, V-Start recoil starter,
instructions

REQUIRES: Muffler, mounting rails, driveshaft, running hardware and 2-cycle oil

SPECS:    Displacement:                             1.5 cid (23.9cc)
Practical RPM:                            3000-12,000 RPM
Output:                                   3 bhp @10,000 RPM
Weight:                                   3.8lbs (1724g)
Fuel ratio, gas/oil mix:                  40:1 mix
On-Center Mounting Holes, Front to Rear:  54mm (2.13")
On-Center Mounting Holes, Side to Side:   69mm (2.72")
On-Center Exhaust Mounting Holes:         29mm (1.14")
Back of Engine to Front of Flywheel:     132mm (5.20")
Engine Height, including spark plug:     172mm (6.77")
Driveshaft adapter thread size:            M6x1
Crankshaft thread size: 5/16-24

COMMENTS: The photo of this engine in its instruction manual and other sources
show a muffler attached. However, the muffler is NOT included and
must be purchased separately. For muffler set, use FJIG5990.

Fuji Imvac is NOT related to the original Fuji engines sold by MECOA.

ACCESSORIES

THIS IS A GASOLINE ENGINE FOR LARGER SCALE BOATS.
INCLUDES: SPARK PLUG, ENGINE MOUNT, PLUG WRENCH, INSTRUCTION MANUAL
REQUIRES: MUFFLER, PROP, 2-CYCLE OIL, GASOLINE, CUT-OFF SWITCH, GASOLINE FUEL
TUBING