FUTJ51   Futaba   3FR SS 3-Channel AM/2 S3003 Servos 

TECH NOTES
  This is a Futaba 3FR Skysport SS3 (Single Stick) AM 3 Channel Radio System.
    Designed for Electric, 1/2A Airplanes, Gliders, or Hand Launch Gliders.
       Available in 27MHz (channels A1-A6) and 72MHz (channels 11-60)

FEATURES: Single stick design on the right side of the transmitter.
          Designed for aileron, elevator or rudder and throttle control.
          Proportional third channel slide switch on the front left side of
            transmitter.
          V-tail or Elevon mixing
          An ergonomically designed transmitter case contoured to fit the
            pilots hand, with a left-thumb recessed area, and an "S" curve
            shape for positioning the right hand naturally while operating the
            stick. The side-to-side stick movement follows the natural geometry
            of thumb motion at approximately a 10 degree angle.
            (other single stick radios use a horizontal side-to-side motion)
          Servo reversing switches for 2 channels (aileron and elevator) are
            on the lower front face of the transmitter. The 3rd switch is for
            turning on the "V-tail Mix" feature on and off.
          Mechanical trims.
          R114H BEC receiver is included.
          2-LED battery level (green-full, flashing red-low voltage).
          Charging jack is pre-installed for optional NiCd batteries.
          Narrow band, excellent for adjacent channel rejection.
          One year warranty.

INCLUDES: One Transmitter with TX crystal installed.
          One Transmitter Antenna     (FUTM5111)
          One R114H AM Narrow Band BEC Receiver either ( FUTL0400 27MHz or
                                                         FUTL0404 75MHz
                                                         FUTL0407 72MHz Lo
                                                         FUTL0408 72MHZ High)
          One Receiver Crystal       (FUTL46** 27MHz or
                                      FUTL49** 75MHz
                                      FUTL47** 72MHz Lo
                                      FUTL48** 72MHz High)
          Two S3003 Standard Servos    (FUTM0031)
          Two S3003 Servo Accessory Packages  (FUTM3551)
          One Switch Harness w/BEC Connector  (FUTM4382)
          One Micro Receiver Battery Box w/BEC Connector  (FUTM1590)
          One Frequency Identification Flag Set (NO NUMBER)
          One Instruction Manual   (NO NUMBER)

REQUIRES: (8) AA batteries for transmitter
          (4) AA batteries for receiver

SPECS:    Transmitter: Current Drain: 180mA
          Receiver: Current Drain:    18mA

COMMENTS: There are no optional transmitter NiCd battery packs for this radio,
            but you can use the included battery box, purchase rechargeable
            Nicd's and then use the charger FUTM1800.               

|  Homepage  |  Crystals  |  Flight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |