FUTJ54     3FR R114F 2-S3114 Tx NiCD 

TECH NOTES

This is a Futaba 3FR Skysport SS3 (Single Stick) FM 3 Channel Radio System
with two S3114 Micro High Torque Servos.
Does not include servo accessory packages or receiver battery.

Designed for Electric, 1/2A Airplanes, Gliders or Hand Launch Gliders.
Available in 72MHz (channels 11-60)

This Futaba radio is diode protected to prevent overcharging, which means that
the battery cannot be discharged through the transmitter.

FEATURES: Single stick design on the right side of the transmitter
Designed for aileron, elevator or rudder and throttle control
Proportional third channel slide switch on the front left side of
transmitter
V-Tail mixing/elevon
An ergonomically designed transmitter case contoured to fit the
pilot's hand, with a left-thumb recessed area, and an "S" curve
shape for positioning the right hand naturally while operating the
stick. The side-to-side stick movement follows the natural geometry
of thumb motion at approximately a 10° angle.
Servo reversing switches for 2 channels (aileron and elevator) are
on the lower front face of the transmitter. The 3rd switch is for
turning the "V-tail Mix" feature ON and OFF.
Mechanical trims
R114F BEC receiver is included
2-LED battery level (Green-full, flashing Red-low voltage)
Charging jack is pre-installed for included Tx NiCd battery
Narrow band, excellent for adjacent channel rejection
One year warranty

INCLUDES: One Transmitter with Tx crystal installed
One Transmitter Antenna                   (FUTM5111)
One R114F FM Narrow Band BEC Receiver    (FUTL0442 Lo or FUTL0443 Hi)
One Receiver Crystal                     (FUTL62** Low or High)
One Transmitter NiCd battery             (FUTM1440)
One Charger                              (FUTM1800)
Two S3114 Micro High Torque Servos       (FUTM0414)
One Switch Harness w/BEC Connector       (FUTM4505)
One Frequency Identification Flag Set      No Number
One Instruction Manual                     No Number

OPTIONAL: *FUTM1435   NT8F Tx NiCd 9.6V 1000M

SPECS:    Transmitter: Current Drain: 180mA
Receiver: Current Drain:    18mA
Servo       6V                    4.8V
Torque: 23.6 oz/in            21 oz/in
Speed:  .09 sec/60°         .10 sec/60°
Dimensions: .86 x .43 x .78" (21.8 x 11 x 19.8mm)
Weight: .275oz (7.8g)

COMMENTS: This radio is Diode Protected so the transmitter battery cannot be
Discharged or Cycled while in the transmitter. Battery Dischargers
and voltmeters Will Not work with this transmitter. To Cycle the
transmitter battery, take it out of transmitter and cycle it
directly.

Order FUTL96** if crystal set is needed.

|  Homepage  |  Crystals  |  Flight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |