FUTJ67     7CAP PCM R168DP 4 S3151 

TECH NOTES

This is the Futaba 7CAP 7-Channel 72MHz Computer Aircraft Radio
with the R168DP 8-Channel PCM Receiver and four S3151 Digital Servos.

FEATURES: 10-model memory and 6-character model naming
Same Dial n' Key programming found on Futaba's 9C systems
Basic menu for everyday sport flying, Advanced menu for more
complicated routines
Heli and airplane control layouts in FM or PCM
Airplane specific features:
Flaperon
Flap Trim
Air Brake
Elevator to Flap
Flap to Elevator
V-Tail Mixing
Elevon Mixing
Aileron to Rudder
Snap
Mode Select feature
Fail Safe (in PCM mode only)
Adjustable throttle cut
Throttle curve normal (5 points)
Pitch curve normal (5 points)
Three programmable mixes
VR switch controls proportional 7th channel
EEPROM memory feature retains settings even when transmitter battery
is disconnected or removed
Stick Mode Select Feature-IMPORTANT, For full mode changes,
transmitter must be sent to the Futaba Service Center
Dual Rates on 4 Channels
Triple rates available if using the 3 position switch
Full function micro (square) trainer system, use FUTM4415
or FUTM4420 (training system only works in FM mode)
One year limited warranty

INCLUDES: One Futaba 7CAP 7-Channel Aircraft Radio with
Four S3151 Digital Servos   FUTM0310
R168DP PCM 72MHz receiver   FUTL0806
600mAh NT8S600B TX battery  FUTM1457
600mAh NR-4J RX battery     FUTM1280
FBC-19B (4) Wall charger    FUTM1830
Transmitter and receiver crystals
Servo accessory bag, frequency flag set, neck strap, ON/OFF switch,
and instruction manual

REQUIRES: Charging batteries overnight before use

SPECS:    Transmitter:
Transmitting Frequency: 72MHz band
Modulation: FM/PPM or PCM, switchable
Power Supply: 9.6V NT8S600B NiCd battery
Current Drain: 250mA

FP-R168DP PCM Dual Conversion Receiver:
Receiving Frequency: 72MHz band
Intermediate Frequency: 10.7MHz & 455kHz
Power Requirement: 4.8V (shared with servos)
Current Drain: 10mA (at no signal)
Size: 1.1 x 2.2 x .8" (28.5 x 55.5 x 19.8mm)
Weight: 1oz (28g)

S3151 Standard Size Digital Servo:
Control System: Pulse width control, 1.52ms neutral
Power Requirement: 4.8V
Output Torque: 43 oz-in (3.1 kg-cm) at 4.8V
Operating Speed: .21 sec/60° @ 4.8V
Size 1.59"x .79"x1.42" (40.5x20x36.1mm)
Weight: 1.48oz (42g)

COMMENTS: For additional helpful information, consider purchasing the
Traplet Publications Futaba 7C The User's Guide, TPNZ1007.

|  Homepage  |  Crystals  |  Flight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |