FUTK61   6EXH PCM Computer Micro R146iP 4 S3103 

TECH NOTES
         This is the Futaba 6EXH 6-channel Helicopter Radio with the
          R146IP Mini PCM Receiver and four S3103 Micro Mini Servos.

    **Additional Technical Info Will Be Added When It Beomes Available.**

    This radio is diode protected to prevent overcharging, which means that
            the battery cannot be discharged through the transmitter.

FEATURES: Six model memory, four character model naming
          Multiple swash plate styles, data reset, trainer capability, EPA,
            exponential and digital trims
          Data Input Lever allows easy setting of end points and rates for all
            six channels
          Five-point adjustment with two curves on both Throttle Curve, Pitch
            Curve, Normal and Idle Up
          Rate selection on both gyro mixing and revo mixing
          Small speaker in face plate emits audio alarms
          Throttle Hold switch for performing autorotation maneuvers and
            reducing idle for starting
          One year limited warranty

INCLUDES: 6EXH 6-Channel Transmitter
          R146IP Mini PCM Receiver, FUTL0601
          Four S3103 Micro Mini Servos, FUTM0037
          NT8F600B 600mAh Transmitter Battery, FUTM1440
          FBC-19B (4) Wall charger, FUTM1830
          Neckstrap, frequency flag set, servo mounting hardware with extra
            servo horns

REQUIRES: Charging batteries overnight

SPECS:    Transmitter-
            Modulation: FM (PPM) and PCM 1024
            Power Supply: 9.6V NT8S600B NiCd battery or 12V alkaline battery
            Current Drain: 250mA
            Power Requirement: 4.8 to 6.0 volts (shared with servos)
            Current Drain: 10mA

          R146IP Receiver-
            Length: 1.12" (28.7mm)
            Width:  1.68" (42.7mm)
            Height: 0.79" (20mm)
            Weight: 058oz (16.5g)
            Receiving range: 984' (300m) appriximate
            Power requirement: 4.8 volt-6 volts.

          S3103 Servos-
            Speed:  .11 sec/60 deg @ 4.8V - .09 sec/60 deg @ 6V
            Torque: 17.0 oz/in @ 4.8V - 21 oz/in @ 6V
                    1.2 kg/cm @ 4.8V - 1.5 kg/cm @ 6V
            Length: 23mm (.9")
            Width:  10mm (.4")
            Height: 20mm (.8")
            Weight:  9.5g (.3oz)

COMMENTS: If using as a trainer radio, one of the following trainer cords will
           be needed;
             9C to FM-FUTM4420 trainer cord to connect to standard trainer port
             9C to 9C-FUTM4415 trainer cord when using a 9C or another 6EXA