FUTS3010   Futaba   S3010 Standard High-Torque Servo

TECH NOTES
             This is the Futaba Standard Size High Torque Servo.
        Alkaline batteries are not recommended for this servo as they do
          not have quite enough power and will not give the best torque.

FEATURES: Ideal for high-torque applications requiring a standard size servo
          Universal connector fits Futaba, Hitec, JR, KO Propo, Airtronics Z,
            and Tower Hobbies. Does not fit old Airtronics A plug w/out adapter
          Nylon gears
          One bearing pre-mounted on output shaft.

INCLUDES: One Futaba standard size high torque servo with,
            One 1.4"  (35mm) diameter round servo wheel
            One 1.5"  (39mm) diameter 4 point servo wheel
            One 1.25" (32mm) diameter 6 point servo wheel
            Four 2mm x 11mm phillips screws
            Four rubber grommets
            Four metal eyelets

REQUIRES: Small phillips screwdriver (can use HCAR1070) to mount to surface

SPECS:   Speed: .20 sec/60 deg. @ 4.8V and  .16 sec/60 deg. @ 6.0V
         Torque: 72 oz/in @ 4.8V and 90 oz/in @ 6V
                  5.2 kg/cm @ 4.8V and 6.5 kg/cm @ 6V
         Length not including mounting flanges: 1.6"  (40mm)
         Length at center of mounting holes:    1.9"  (49.5mm)
         Width total:                           0.8"  (20mm)
         Width at center of mounting holes:     0.40" (10mm)
         Height not including servo horn:       1.5"  (38mm)
         Weight:                                1.4oz) (41g)

COMMENTS: Use only NiCd batteries with this servo in all applications. NiCds
            have a slow discharge rate allowing you to retain control of your
            model as the voltage diminishes. NiMH batteries discharge voltage
            suddenly which could operator to lose control of model.

|  Homepage  |  Batteries  |  Crystals  |  Flight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |