FUTS9153   Futaba   S9153 Digital Aileron/Elev High Torque/Speed BB

TECH NOTES
                 This is the S9153 Aileron/Elevator Servo.
                 Comes with "J" Connector Pre-Installed.
     Metal case acts as a Heat Sink to reduce Heat and is designed to be
                          Water and Dust Proof.

 ++ Additional Technical Information Will Be Added As It Becomes Available. ++

FEATURES: Comes with Heavy Duty wiring that can handle Higher Current Loads.
          New Metal casing which helps to dissipate heat.
          Coreless Motor
-
-
          High Torque
          One year warranty.

INCLUDES: One Digital High Torque Servo
-         Four Rectangular Grommets
-         Four Brass Bushings
-         Four Mounting Screws
-         One Large Round Horn
-         One Six Arm Horn
-         One Four Arm Horn

SPECS:    Speed:  .16 sec/60 degrees @ 6V
          Torque: 222 oz/in @ 6V ( 10.0 kg/cm )
          Weight: 2.6 oz (74g)
          Dimensions: 1.9x1.6x1.0in (48x41x25.4mm)

COMMENTS: S9153 Digital Servo Precautions,
          -It is best to avoid long leads and Y-harnesses especially with
           standard grade wires.  If problems are encountered, consider using
           heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
           Pro Series ,minimizing lead lengths, and/or removing Y-harnesses.
           -Current Drain:  Futaba S9153 Servo is Specially Designed for High-
            Torque and High-Speed, Therefore Very High Current Drain Is
            Normal At Startup.  For Ultimate Performance When Using This Servo
            Please Review The Following Points.
            (1) When Using Systems With the Battery Fail Safe Function it Has
              a Higher Cut-Off Voltage Setting Which Will Cause Shorter
              Operation Time.
            (2) When Installing the Servo Please Check Pushrod Linkage To Make
              Sure There Is No Binding in Order To Prevent Excessive Power
              Consumption and Decrease the Life of the Motor and Battery.
         This digital servo cannot be used with the following * AM *
               transmitters as the servo neutral signal is: 1310us).
        CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terra-
              top, T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.

      ****   Otherwise they will work fine with current AM systems  *****

|  Homepage  |  Batteries  |  Crystals  |  Flight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |