Futaba, S9154 Digital High Speed Aileron Servo

TECH NOTES
    This is the Futaba S9154 Digital Low Profile High Speed Aileron Servo
                              with J Connector.
             Designed for aileron applications on model aircraft.

  **Additional Technical Information Will Be Added When It Becomes Available**

FEATURES:            motor
          Digitally enhanced microprocessors cut in half the response time
            from transmitter input to servo reaction
          Dust and water resistant-not water proof
          Low profile aero design is specially suited for wing installations
            with thin airfoils
          Black plastic case
          One year warranty

INCLUDES: One S9154 Digital high speed aileron servo
             diameter servo wheel,
            four brass grommets, four mounting screws and two rubber mounts.

SPECS:    Speed:        0.14 sec/60 deg @ 4.8V
          Torque:       64 oz/in @ 4.8V (5.8 kg/cm @ 4.8V)
          Length:       1.9"   (48mm)
          Width:        1.1"   (28mm)
          Height:       1.0"   (25mm)
          Weigth:       1.9 oz (53g)
          Power Supply: 4.8V (Futaba does NOT recommend using 6V)

COMMENTS: S9154 Digital Servo Precautions,
           -It is best to avoid long leads and Y-harnesses especially with
            standard grade wires. If problems are encountered, consider using
            heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
            Pro Series,minimizing lead lengths, and/or removing Y-harnesses.
           -Current Drain: This digital servo is specially designed for high-
            torque or high-speed, therefore very high current drain is normal
            at startup. For ultimate performance when using this servo please
            review the following points.
              1. Radio systems with the Battery Fail Safe function have a
                 higher cut-off voltage setting which will cause shorter
                 operation time.
              2. When installing the servo, please check pushrod linkage to
                 make sure there is no binding in order to prevent excessive
                 power consumption and decrease the life of the motor and
                 battery.

         This digital servo cannot be used with the following * AM *
               transmitters as the servo neutral signal is: 1310us.
        CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terra-
              top, T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.

      *****  Otherwise they will work fine with current AM systems  *****

            No other arms will work on this servo, because of the unique
              spline size.