FUTS9250   Futaba   S9250 Servo Digital Heli

TECH NOTES
            This is the S9250 Digital Servo w/Two Ball Bearings for
    Helicopter and Aircraft use and Comes with "J" Connector Pre-Installed.

FEATURES: Digitally Enhanced Microprocessors Cut About 1/2 of the Response
            Time From Transmitter Input To Servo Reaction.
          Coreless Motor
          Dual Ball Bearing Output Shaft
          Metal Gears
          High Speed
          Case is Made of Black Plastic
          Dust and Water Resistant (Not Waterproof)
          Great for Helicopters or Airplanes Where Higher Torque and Speed are
            Needed.
          One year warranty.

INCLUDES: One Digital Helicopter/Aircraft Servo w/Small Round Horn
          Four Rectangle Grommets
          Four Brass Bushings
          Four Mounting Screws
          One Large Round Horn
          One Six Arm Horn

SPECS:    Speed:  .11 Sec/60 Degrees (based on 4.8 Volts)
          Torque: 76.3 oz/in (5.5 kg-cm) (based on 4.8 Volts)
          Weight: 1.90 oz (54 g)
          Power Supply: 4.8 Volts (Futaba does not recommend using 6 volts)
          Length: 1.59" (40.5mm)
          Width:  0.79" (20mm)
          Height: 1.48" (37.5mm)

COMMENTS: S9250 Digital Servo Precautions,
          -It is best to avoid long leads and Y-harnesses especially with
           standard grade wires. If problems are encountered, consider using
           heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
           Pro Series ,minimizing lead lengths, and/or removing Y-harnesses.
           -Current Drain: Futaba S9250 Servo is Specially Designed for High-
            Torque and High-Speed, Therefore Very High Current Drain Is
            Normal At Startup. For Ultimate Performance When Using This Servo
            Please Review The Following Points.
            (1) Always use a 4.8 volt NiCd w/gyro. Dry cells are rated at
              1.5 volts each making the overall voltage 6.0 volts which will
              damage the **gyro**. The servo operates fine on 6.0 volts.
            (2) When Using Systems With the Battery Fail Safe Function it Has
              a Higher Cut-Off Voltage Setting Which Will Cause Shorter
              Operation Time.
            (3) When Installing the Servo Please Check Pushrod Linkage To Make
              Sure There Is No Binding in Order To Prevent Excessive Power
              Consumption and Decrease the Life of the Motor and Battery.
          When Used With GY501 Gyro:
            Switch the GY501 Servo Frame Rate Function (Frm) from "NOR" to
            "High" to Display the Performance of the Gyro to the Fullest.
            Setting Method:
            (1) Press the GY501 FUNC+ or - key to call the Servo Frame Rate
              Setup Screen.
            (2) Press the DATA+ or - key to display "High".
          This Digital Servo Cannot Be Used With The Following Transmitters:
            (Servo Neutral Signal: 1310us)
            Conquest AM, FG Series (T4FG, T5FGK, T6FG, T6FGK. T7FGK), New
            Terratop, T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK Series.
                                           

|  Homepage  |  Batteries  |  Crystals  |  Fight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |