FUTS9351   Futaba   S9351 Digital High Torque Servo 

TECH NOTES
        This is the S9351 Digital High Torque Coreless Servo for Car
         and Boat Use and Comes with "J" Connector Pre-Installed.
              Metal case acts as a Heat Sink to reduce Heat.

FEATURES: Comes with Heavy Duty wiring that can handle Higher Current Loads.
          New Metal casing which helps to dissipate heat.
          Coreless Motor
          High Torque
          Great for 1/8 Cars or Boats Where Higher Torque and Speed are Needed.
          One year limited warranty.

INCLUDES: One Digital High Torque Servo w/Small Round Horn and 7.5" (190mm)
            wire lead
          Two Rectangular Grommets
          Four Chrome Bushings
          One "T" Horn

SPECS:    Speed:  .13 Sec/60 Degrees @ 6.0V
          Torque: 192 oz/in @ 6V
          Weight: 2.15 oz (63g)
          Length: 1.57" (40mm)
          Width:  0.8" (20mm)
          Height: 1.44" (36.6mm)

COMMENTS: S9351 Digital Servo Precautions,
          -It is best to avoid long leads and Y-harnesses especially with
           standard grade wires. If problems are encountered, consider using
           heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
           Pro Series, minimizing lead lengths, and/or removing Y-harnesses.
           -Current Drain:  Futaba S9350 Servo is Specially Designed for High-
            Torque and High-Speed, Therefore Very High Current Drain Is
            Normal At Startup. For Ultimate Performance When Using This Servo
            Please Review The Following Points.
            (1) When Using Systems With the Battery Fail Safe Function it Has
              a Higher Cut-Off Voltage Setting Which Will Cause Shorter
              Operation Time.
            (2) When Installing the Servo Please Check Pushrod Linkage To Make
              Sure There Is No Binding in Order To Prevent Excessive Power
              Consumption and Decrease the Life of the Motor and Battery.
         This digital servo cannot be used with the following * AM *
               transmitters as the servo neutral signal is: 1310us).
        CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terra-
              top, T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.

            ***** Do not use digital servos with AM systems *****

|  Homepage  |  Batteries  |  Crystals  |  Flight Packs  |  Radio Accessories  |  Radio's  |  Receivers  |  Servo's  |   Search  |