TECH NOTES
This is a radio controlled, electric powered, foam
Great Planes FlatOuts Extra 300S 3D Profile Park Flyer Airplane.
For Intermediate to Advanced Modeler/Fliers.

FEATURES: Construction: 1/8" (3mm) thick foam w/ carbon fiber reinforcing rods
to strengthen the infrastructure
Wings: 1/8" (3mm) thick foam with with carbon fiber leading edge
and trailing edge reinforcement
Landing Gear: 0.08" (2mm) diameter carbon rod landing gear legs
with 1-1/8" (28mm) diameter wheels, 3/8" (10mm) diameter tailwheel
snaps into carbon fin post and steers the airplane while on the
ground
Wheel Pants: 1/4" (6mm) thick foam construction
Building Time: Flight ready in 2-3 hours
Hardware: Carbon fiber pushrods and wing struts, clip-hinge system
on tail section allows up to 80° of deflection without binding and
also pops loose in the event of a crash
Motor: T-370 size Brushed
Gearbox: 5:1 gear ratio
Propeller: 10x3.8 Slo-Flyer with prop saver
Warranty: Great Planes Model Manufacturing Company guarantees this
kit free from defects in both materials and workmanship at
the date of purchase.

INCLUDES: Extra 300S foam construction 3D airplane, 370 size motor,
5:1 gearbox, 10x3.8 Slo-Flyer propeller,
hardware and instructions

REQUIRES: Speed Control: 10A
Battery: 3S 350 - 700mAh Lithium Polymer
Charger: Lithium Polymer capable
Radio: 4-Channel
Servos: 3 Micro (10g or less)
Two 200mm Servo Extensions: FUTM4508
Misc. Items: Foam safe CA, Building and Field Equipment

SPECS:    Wingspan: 35.5" (900mm)
Wing Area: 223 sq in (14.4 sq dm)
Weight: 7.5 - 9oz (215 - 255g)
Wing Loading: 4.8 - 5.8oz (15 - 18g/sq.dm)
Length: 29.5" (750mm)
Center of Gravity: 2-1/4" (57mm) Back from the wing's leading edge
at the fuselage sides.
Function: High rate endpoints  High rate travel  High rate exponential
Aileron       +/- 100%           +/- 55-60°      40%
Elevator      +/- 100%           +/- 55-60°      40%
Rudder        +/- 100%           +/- 55-60°      40%
Low rate endpoints          Low rate travel  Low rate exponential
Aileron       +/-  40%           +/- 15-25°       0%
Elevator      +/-  40%           +/- 15-25°       0%
Rudder        +/-  40%           +/- 15-25°       0%

COMMENTS: The ElectriFly 720mAh battery is not capable of delivering the
current required by this system.
Great Planes recommends using Foam safe Thick CA GPMR6072 for
this plane. Regular CA is not recommended as it will attack the
foam used in this plane.
If you upgrade to the RimFire motor (GPMG4500), a 9x3.8 prop is
required as well as the ElectriFly BL-8 ESC (GPMM2070).
****If you are going to use the Variable Pitch motor and prop you
will need to use at least a 6 channel transmitter.****