GPMR8140   Great Planes   Groove Tube Grooving Tool 

TECH NOTES
        This is the Groove Tube-Grove Cutting Tool from Great Planes.

           This tool cuts perfect grooves in balsa for installing
           elevator joiner wires, aileron torque rods and bearings,
       tail gear wires and bearings, or to clean pushrod exits in fuselages.

FEATURES: Creates crisp, clean grooves in balsa by using a back and forth
            twisting motion.
          Creates a uniformly round groove that increases the rod's
            performance - without the need for sanding.
          Much safer than using a hobby knife or drill to gouge out the wood.

INCLUDES: One Groove Tube Cutting Tool (in a storage tube, mounted on a
            photo illustrated header card with usage instructions.

SPECS:    Groove Cutting Tube   Length: 4" (112mm)
                              Diameter: 1/8" (3mm)
          Plunger Rod           Length: 5-1/8" (131mm)
          Plunger Spring        Length: 1-1/2" (40mm)

COMMENTS: Caution: Always grasp the part behind the sharp edge of the cutting
            tube, and cut away from your body.
          For hard balsa, make two or three shallow cuts rather than one deep
            one.
                                                                     

|  Homepage  |  R/C Airplanes  |  Accessories  |  Batteries  |   Chargers  |  Covering  |  Decals  |  Electronic Speed Controls  |  Engines  |

|  Engine Mounts  |  Field Equipment  |  Fuel  |  Fuel Tanks  |  Glow Plugs  |  Glues  |  Landing Gears  |  Nuts/Bolts  |  Paint  |  

|  Paint Supplies  |  Props  |  Push Rods  |  Radios  |  Simulators  |  Spinners  |  Tools  |  Wheels  |  Search  |