GPMM1810   Silver Series 12A Brushless ESC 5V/1A BEC

TECH NOTES
This is the ElectriFly Silver Series 12 Amp Brushless Electronic Speed Control.

FEATURES: Compatible with NiCd, NiMH and Li-Po batteries
          Auto-detects input volts/battery type, and sets low-voltage cutoff
          8.5kHz switching frequency, for good run-time and cool operation
          Pre-installed universal radio connector* (see Comments below)
          Pre-installed polarized micro connector for battery
          Pre-installed gold plated 2mm female bullet connectors for motor
          High powered BEC (battery eliminator circuitry) which handles 2 or 3
           micro servos (4 if adequate airflow is provided)
          Full proportional forward and smooth throttle response with on/off
            brake
          Safe Start System** (see details in Comments below)
          Thermal Protection stops motor when maximum temperature 230°F
           is reached

INCLUDES: One Brushless Electrifly Silver Series 12 Amp Speed Control with
            pre-installed receiver connector, battery connector, and motor
            connectors.

REQUIRES: Installing in airplane and connecting to receiver, battery and motor

SPECS:    Length: 1.30" (33mm)
          Width:  0.91" (23mm)
          Height: 0.24  (6mm)
          Weight: 0.49oz (14g)
          Input Voltage: 6-12 cells NiCd/NiMH
                         2-4 cells Li-Po
                         (20V input w/o BEC)
          Output Current: 12A continous maximum
                          15A surge maximum
          Max Output Power: 150 watts
          On-resistance: 0.03 ohms
          Operating frequency: 8.5kHz fixed
          BEC: 5V/1.5A
          Low Voltage Cutoff: Battery voltage x 0.67
          Thermal Cutoff: 230°F (110°C)
          Timing Angle: 12 degrees
          Brake: On/Off

Typical Application: Great for small, lightweight, high performance airplanes
                     from flat-foams to built-up 3D's. Great for out runner
                     style brushless motors, delivering 12 amps of continuous
                     current with a built-in Battery Eliminator Circuit which
                     can handle 1.5 amps.  Simple to use and very affordable.

COMMENTS: For mating motor connectors, can use:  GPMM3110
          For mating battery connector, can use: WSDM3007
          *To use with "Old Airtronics" RX, requires adapter: AIRM4400
          **Safe Start System: Move throttle stick to full throttle position,
           then to "off" position, then slowly advance throttle and motor will
           begin to run.

          180 Day Warranty (USA & Canada Only)

|  Homepage  |  ARF  Planes  |  Electric  |  Kits  |  Park Flyers  |  Park Flyer Accessories  |  Sailplanes  |  Search  |