GPMM2005   C-7 Nano Brushed ESC w/BEC

TECH NOTES
      This is the C-7 Nano High Frequency Electronic Speed Control w/BEC.
       For very small indoor, park and backyard flyers with 280-size or
                 smaller brushed motors requiring 7A or less.

FEATURES: Extremely compact size to minimize weight and simplify installation
          Set battery type with included jumpers
          Uses "Safe-Start" system to prevent accidental motor starts by
            disabling the motor circuitry until the throttle stick is moved to
            full throttle, then to the OFF position
          Factory installed motor, radio and battery connectors
          Fully proportional forward only (no brake)
          Battery Eliminator Circuitry provides sufficient current for the
            receiver and two to three micro servos. The motor battery powers
            the receiver and servos, then when voltage is reduced to the
            appropriate voltage, the low voltage cut-off circuitry stops the
            motor while continuing to supply power to the receiver and servos
          High frequency to optimize battery run-time and cool operation.
          Bright blue LED and audible tones for easy set-up
          Very smooth throttle response
          180 day limited warranty

INCLUDES: One C-7 Nano Electronic Speed Control with Deans polarized micro
            connector for battery, 2mm gold plated female bullet motor
            connectors and universal receiver connector and separate pre-
            assembled leads with male and female 2-pin connectors
          One instruction sheet.

REQUIRES: Attaching to motor and setting up speed control
          Battery pack
          Plug Universal plug into the throttle channel on the receiver

SPECS:    Length:              .66" (17mm)
          Height:              .28"  (7mm)
          Width:               .43" (11mm)
          Weight:              0.20 ounce (5.5g) with wires
          Input:               6-8 NiCd/NiMH cells; 2-3 Li-Po cells
          Max Rated Current:   7A continuous
          BEC Voltage:         5V/1A
          Low Voltage Cutoff:  0.80V per cell for NiCd/NiMH,
            2.75V per cell for Li-Po.
          Connectors: Receiver lead- Universal
                      Battery lead- Deans 2R micro connector
                      Motor Connector- 2mm gold plated female bullet connectors
          Switching Frequency: 2.5 kHz
          Motor Size:          280 or less brushed only

COMMENTS: Will handle 3 micro servos with proper cooling.
          Do NOT use with brushless motors.

|  Homepage  |  ARF  Planes  |  Electric  |  Kits  |  Park Flyers  |  Park Flyer Accessories  |  Sailplanes  |  Search  |