GPMM2035   C-35 Mini Brushed ESC w/BEC

TECH NOTES
      This is the C-35 Mini High Frequency Electronic Speed Control w/BEC.
        For medium sized performance aircraft with 400, 500 or 600-size
                       brushed motors requiring 35A or less.

FEATURES: Compact size to minimize weight and simplify installation
          Programmable battery types
          Automatic temperature protection reduces max throttle to 70% when max
            temperature is reached
          Uses "Safe-Start" system to prevent accidental motor starts by
            disabling the motor circuitry until the throttle stick is moved to
            full throttle, then to the OFF position
          Factory installed radio, motor and battery connectors
          Fully proportional forward with brake
          Battery Eliminator Circuitry provides sufficient current for the
            receiver and three standard servos. The motor battery powers the
            receiver and servos, then when voltage is reduced to the
            appropriate voltage, the low voltage cut-off circuitry stops the
            motor while continuing to supply power to the receiver and servos
          Solid-state current overload limiter
          Built-in thermal protection reduces throttle to 70% if the
            transistors overheat
          Reverse-polarity protection
          High Frequency to optimize battery run-time and cool operation.
          ON/OFF radio switch and set-up LED light
          180 day limited warranty

INCLUDES: One C-35 Mini Electronic Speed Control with universal receiver
            plug installed, installed motor wires with 3.5mm gold plated
            female bullet connectors, Deans Ultra male battery connectors,
            and an ON/OFF switch
          Three ceramic capacitors to reduce motor noise.
          One Schottky SR506 diode for added efficiency.
            (silver stripe indicates Positive unless using with gearbox)
          One 2.75" piece of shrink tubing.
          One instruction sheet.

REQUIRES: Attaching to motor and setting up speed control
          Battery pack
          Plug universal plug into the throttle channel on the receiver

SPECS:    Length:              1.30" (33mm)
          Width:               .71" (18mm)
          Height:              .43" (11mm)
          Weight:              1.08 ounce (30.5g) with wires
          Input:               6-12 NiCd/NiMH cells; 2-4 Li-Po cells
          Max Rated Current:   35A continuous
          BEC Voltage:         5V/1.5A
          Low Voltage Cutoff:  0.80V per cell for NiCd/NiMH, 2.75V per cell for
            Li-Po
          Connectors: Universal radio connector, Deans Ultra male battery
            connector, 3.5mm gold plated female bullet connectors
          Switching Frequency: 1.3kHz
          Motor Size:          Speed 400, 500 and 600-brushed only

COMMENTS: Motor wires are white (positive) and blue (negative).
          Do not use with brushless motors.

|  Homepage  |  ARF  Planes  |  Electric  |  Kits  |  Park Flyers  |  Park Flyer Accessories  |  Sailplanes  |  Search  |