GPMM2055   C-55 Mini Brushed ESC w/BEC 

TECH NOTES
      This is the C-55 Mini High Frequency Electronic Speed Control w/BEC.
  For aircraft requiring high current with 500 or 600 size Brushed motors
                             requiring 50A or less.

FEATURES: Compact size to minimize weight and simplify installation
          Programmable battery types
          Automatic temperature protection reduces max throttle to 70% when max
            temperature is reached
          "Safe-Start" system prevents accidental motor starts by disabling the
            motor circuitry until throttle stick is moved to full throttle,
            then to the OFF position
          Factory installed radio, motor and battery connectors
          Fully proportional forward with brake
          Battery Eliminator Circuitry provides sufficient power for the
            receiver and three standard servos. The motor battery powers the
            receiver and servos. When voltage is reduced to the appropriate
            value, the low voltage cut-off circuitry stops the motor while
            continuing to supply power to the receiver and servos.
          Solid-state current overload limiter
          Built-in thermal shutdown protection drops throttle to 70% if
            transistors overheat
          Reverse-polarity protection
          High Frequency to optimize battery run-time and cool operation
          ON/OFF radio switch and set-up LED light
          180 day limited warranty

INCLUDES: One C-55 Mini Electronic Speed Control with Universal receiver plug
            installed, installed motor wires with 4mm gold plated Female
            Bullet Connectors, Deans Ultra Male Battery Connector and an
            ON/OFF switch
          Three ceramic capacitors to reduce motor noise.
          One 2.75" piece of shrink tubing.
          One instruction sheet.

REQUIRES: Attaching to motor and setting up speed control
          Battery pack
          Plug Universal plug into the throttle channel on the receiver

SPECS:    Length:              1.42" (36mm)
          Width:               .71" (18mm)
          Height:              .43" (11mm)
          Weight:              1.22 ounce (35g) with wires
          Input:               6-12 NiCd/NiMH cells; 2-4 LiPo cells
          Max Rated Current:   50A continuous
          BEC Voltage:         5V/1.5A
          Low Voltage Cutoff:  0.80V per cell for NiCd/NiMH
                               2.75V per cell for LiPo
          Connectors: Universal radio connector, Deans Ultra Male Connector,
            4mm gold plated Female Bullet Connectors
          Switching Frequency: 1.3kHz
          Motor Size:          Speed 500 and 600 Brushed only

COMMENTS: Motor wires are White (Positive) and Blue (Ground).
          Do not use with Brushless motors.