GWSA1035   GWS   A10 ARF w/EDF55 DF w/2 370 Motors Gray 38.1"

TECH NOTES
        This is the GWS A-10 Thunder Bolt electric ducted fan series
          airplane with the EDF55 ducted fans powered by 2 370 motors.
          This aircraft is recommended for advanced and expert flyers.
                       Also known as the "Warthog".

FEATURES: Gray foam construction, fully scale appearance
          Wings: One piece foam
          Cowling: Foam ducted fan shrouds
          Canopy: Plastic
          Cockpit features: Included decals for detailing
          Landing gear: Pre-bent main and steerable nose gear.
          Single aileron servo
          Hardware: All necessary hardware included
          Warranty: GWS guarantees this kit to be free from defects in
            both materials and workmanship at the date of purchase.

INCLUDES: All foam fuselage, wings, and tail sections,2 Ultra-lite main wheels,
          1 Ultra-lite nose wheel, main and tailwheel wire pre-bent,
          foam ducted fan shrouds,2 fan units,2 370 motors, Y cord for motors,
          photo-illustrated instructions, all necessary hardware and decals.

REQUIRES: Speed control (20 amp)
          Battery 6N400mAH AA NICD or 6-7N500-730mAh Ni-MH AAA (GWSA7009)
          Charger
          Radio:   3-4 Channel with 4 channel Pico type receiver
          Servos: 3 Pico/Naro servos
                  (1-ailerons, 1-elevator, 1-steerable nose gear)
          Servo Extension 6":   (for ailerons)
          Misc. Cutter knife, pliers, triangle screwdriver, nippers, scissors,
              1/4" foam rubber padding, spay paint, building and field equipment

SPECS:    Wingspan:38.1" (968mm)
          Wing Area:216 sq in (13.95 sq dm)
          Flying Weight:12.7-14.46oz (360-410g)
          Wing Loading:8.46-9.64oz/sq ft (25.8 -29g/sq dm)
          Length:34.3" (872mm)
          Airfoil: Low wing
          Center of Gravity:50-57mm back from the wing's leading edge
            at the fuselage sides.
          Control Throws-           Low Rate       High Rate
            Ailerons: Up & Down       8mm            11mm
            Elevator: Up & Down       11mm           13mm
            Nose steering             8mm            10mm

COMMENTS: GWS does not recommend exceeding the suggested voltage level
          as this may cause damage to the aircraft.