HCAP0332   Hobbico   Voltwatch 2 4.8V/6V Rx Battery Monitor

TECH NOTES
         This is the VoltWatch 2 on-board Receiver Battery Monitor for
                   4.8V and 6V NiCd and NiMH receiver packs.
    This mounts on the outside of the airplane, so you can see at a glance
        the status of the receiver battery mounted inside the airplane.

FEATURES: 7-LEDs provide instant, accurate battery voltage status of Low, Safe,
            or Max. Only one light at a time glows
          Small switch to select 4.8V or 6V battery
          Very lightweight, only .15 oz (4.3grams) unit can be mounted on the
           side of the fuselage, or under the plane's canopy.
          Draws amazingly low current -  from 4-34 mA depending on the battery
           condition
          Plugs into any open receiver channel using a Futaba J connector.
          One year warranty

INCLUDES: One VoltWatch 2 On-Board Receiver Battery Monitor w/Futaba J plug
          One 1.5x1" piece of double sided mounting tape

REQUIRES: Plugging into any unused receiver port
          Mounting onto the airplane with double-sided tape.

SPECS:    Length: 1.65" (42mm)
          Width:  .63" (16mm)
          Height: .16" (4mm)
          Weight: 0.15oz (4.3 grams)
          Current Draw: approx 4-34mA

COMMENTS: This has a Futaba J connector pre-installed. For radios other than
            Futaba, you will have to change or modify the plug.
          Because of reverse polarity, if you would like to use this with the
           older Airtronics batteries, you must also purchase AIRM4400

|  Homepage  |  R/C Airplanes  |  Accessories  |  Batteries  |   Chargers  |  Covering  |  Decals  |  Electronic Speed Controls  |  Engines  |

|  Engine Mounts  |  Field Equipment  |  Fuel  |  Fuel Tanks  |  Glow Plugs  |  Glues  |  Landing Gears  |  Nuts/Bolts  |  Paint  |  

|  Paint Supplies  |  Props  |  Push Rods  |  Radios  |  Simulators  |  Spinners  |  Tools  |  Wheels  |  Search  |