HCAP0351   Hobbico   Expanded Scale Voltmeter MKII 

TECH NOTES
       This Expanded Scale Voltmeter Tests Batteries using a Simulated
                  Servo Load for Precise, Accurate Readings.
       This is used for Testing ONLY Transmitter and Receiver Batteries!
     It CAN NOT be used to Test Capacity or Voltage in Glow Plug Ni-CDs or
                    other Field Batteries Below 4 Volts!
FEATURES: Now also checks 5-cell packs, as well as the 4- and 8-cell packs.
          Approximately 30% smaller and lighter than almost every other
            Expanded Scale Voltmeter on the market. Fits with ease into
            a pocket or any field box.
          Simulated Load on Transmitter side is 250 mA
          Simulated Load on Receiver side is 225 to 275 mA
          Meter backplate includes mirrored alignment area allowing for the
            perfect viewing angle for accurate readings. Meter also includes
            three scales for each pack type, plus dual indicators for each.
          Red and green colored scales, to note dangerous or safe voltages.
          Monitors 9.6V Transmitter, 4.8V, and now 6.0V Receiver Pack
          You can keep track of the batteries' Discharge Characteristics
          Accepts Banana Plug Connectors
INCLUDES: One Expanded Scale Voltmeter MKII
REQUIRES: Connectors to go from the Voltmeter to the Transmitter or Receiver
            Batteries (see COMMENTS).
SPECS:    Length: 2.75"
          Width:  1.25"
          Height: 3.75"
COMMENTS: The modeler may also Purchase the Following Pre-Made Rx and Tx
            connectors, however, it CAN NOT Test Diode-Protected.
            Transmitter Batteries through the Radio Charge Jack. The battery
            must Be Removed from the transmitter to get an accurate reading.
          VOLTMETER CONNECTOR INFORMATION:
            These Receiver Charge Cord comes with Both Tx and Rx Connectors.
            HCAP0104 - Airtronics Radios (ALL Older Standard Connectors)
            HCAP0105 - All JR Radios
            HCAP0106 - All HiTec and New Airtronics Z Connector Radios
            HCAP0102 - Futaba 9VAP Radio Only
            HCAP0101 - All Futaba Radios EXCEPT 9VAP

          Modelers can make their own connectors by purchasing one HCAP0310
            Banana Plugs, One ASCC4181-16 Gauge Wire and their Radio Connector.
          For the older Futaba radios with "G" plugs, the customer will need to
            Purchase One FUTM4210-RX Charge Cord and One HCAP0310.
                                                                    

|  Homepage  |  R/C Airplanes  |  Accessories  |  Batteries  |   Chargers  |  Covering  |  Decals  |  Electronic Speed Controls  |  Engines  |

|  Engine Mounts  |  Field Equipment  |  Fuel  |  Fuel Tanks  |  Glow Plugs  |  Glues  |  Landing Gears  |  Nuts/Bolts  |  Paint  |  

|  Paint Supplies  |  Props  |  Push Rods  |  Radios  |  Simulators  |  Spinners  |  Tools  |  Wheels  |  Search  |