OSMG2116   .18 TZ (P) Slide Carb EB Fully Modified

TECH NOTES
          This is the O.S. Max 18TZ (P) EB Modified RC Vehicle Engine
    with Slide Valve Carburetor and Rear Exhaust for on-road touring cars.
          Hand assembled and balanced and blueprinted to guarantee
    precision parts fit, longest engine life and best possible performance.

        ***This engine does not have the O.S. Max 2 Year Warranty.***
             For all set-up questions and engine service contact-
                                EB MODS
                               Ed Bridges
                            430 Shoemaker St.
                         Swoyersville, PA 18704
                       Shop Phone: (570) 718-0161
                          Fax: (570) 718-0154

FEATURES: Lightened and epoxy filled crankshaft is constructed with two-step
            boring process for improved low end throttle response and broader
            power curve
          Crankshaft is balanced using bob weights to improve balancing ratios
             over stock crankshafts
          Crankshaft face is modified to improve aerodynamics, fuel atomizing
            and balance
          Lightened and strengthened connecting rod for reduced rotating and
            reciprocating weight
          Lightened and modified piston for reduced reciprocating weight and
            improved fuel flow
          Cylinder sleeve is ported to increase port velocity while
            maintaining proper port angles
          Piston and sleeve is matched to increase cylinder sealing area
            and improved power and engine life
          Deck height is set for proper compression ratio and head clearance
            for percentage of nitro in recommended fuel

INCLUDES: O.S. Max 18TZ (P) EB Modified RC Vehicle Engine with 11K Slide Valve
            Carburetor, P3 glow plug, carb gasket and instruction manual

REQUIRES: Fuel: Car blend fuel with 20% nitromethane content

SPECS:    Specs such as bore, stroke, RPM and power output are not provided,
            contact EB MODS for more info.

          Weight:                                                7.6oz (220g)
          Distance between mounting holes same side:             0.43" (11mm)
          Distance between mounting holes opposite side:         1.2" (31.4mm)
          Distance from end of crankshaft to front bearing:      1.16" (29.5mm)
          Distance from backplate to front bearing:              1.96" (49.8mm)
          Distance from backplate to crankshaft end:             3.1" (79.7mm)
          Distance from center of engine to front of crankcase:  1.4" (34.8mm)
          Distance/bottom of mounting flanges/top of cylinder head:3.2"(81.2mm)
          Width of mounting flanges:                             1.5" (39mm)
          Length of exhaust flange:                              0.24" (6mm)
          Crankshaft Threads: 1/4" Diameter x 28 Pitch

                                                       
ACCESSORIES
THE 18TZ (P) EB FEATURES FIVE PORT SLEEVE, LIGHTENED PILOT TYPE CRANKSHAFT,
 MATCHED CYLINDER & PISTON, PORTED CYLINDER SLEEVE, LIGHTENED CON ROD & PISTON,
 P3 GLOW PLUG, 11K 3-NEEDLE SLIDE VALVE CARB
REQUIRES: MODEL SPECIFIC EXHAUST SYSTEM, AIR FILTER, FUEL FILTER, GLOW FUEL,
 & STARTING EQUIPMENT.