TRA4109   Nitro Stampede RTR 2007
| Video |

TECH NOTES
This is the glow powered, radio controlled ready-to-run
Traxxas Nitro Stampede 1/10 scale Monster Truck.

**Additional Technical Info Will be Added When It Becomes Available.**

FEATURES: Chassis: 6061 T-6 aluminum anodized blue
Radio: Traxxas TQ with high torque steering servo, trim and servo
reverse
Engine: Traxxas Pro .15 with two-needle rotary carb and EZ-Start
electric starter
Exhaust: Dual rear tuned
Drive: Rear wheel
Body: Pre-painted, pre-cut polycarbonate body with decals applied
Ball Bearings: Full set included, rubber sealed
Shocks: Four Ultra shocks oil-filled with powder coated white
springs
Slipper Clutch: Adjustable
Suspension: 4-wheel independent
Transmission: Magnum 375 with 32 pitch gears and ball bearings
Differential: Planetary gear with steel internal gears
Fuel Tank: 2.5oz (75cc) with flip-top lid and primer bulb
Brake: Composite disc type
Tires: Revo spec Talon 2.8" (71mm) inner diameter
with foam inserts
Wheels: Traxxas All Star 2.8" (71mm) diameter
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle

INCLUDES: Assembled Nitro Stampede with Pro .15 engine and glow plug,
EZ-Start electric starter, panited body with decals,
TQ pistol grip radio, instruction sheet

REQUIRES: 12 "AA" batteries, fuel, 6-cell battery, charger (for the battery)

SPECS:    Length: 17" (432mm)
Front and Rear Track: 12.75" (324mm)
Weight: 5.2lb (2.35kg)
Height: 9.5" (241mm)
Wheelbase: 10.75" (273mm)
Ground Clearance: 4" (102mm)
Gear Ratio: 3.75:1 (internal)

COMMENTS: For Replacement Ball Bearings use:
Qty.  Size       Location                    Bearing Set Qty.

REPLACING EZ STARTER WITH STANDARD RECOIL STARTER
To convert the EZ starting to a standard "pull starter", purchase
part numbers TRAG5170, TRAP5211 one-way bearing, 4 3x8mm machine
screws, take out the three bolts on the EZ-Starter, clip the wires
on the EZ-Starter, and install recoil pullstart.

Available with the following radio channels and body colors;
TRAC85A2
TRAC85A4
TRAC85A5
TRAC85A6

 |  On-Road Nitro  |  Off-Road Nitro   |   On-Road Electric  |  Off-Road Electric  |  Search  |