TRA4409   Nitro Rustler RTR 2007
| Video |

TECH NOTES
This is the glow powered, radio controlled ready-to-run
Traxxas Nitro Rustler 1/10 scale Stadium Race Truck.

**Additional Technical Info Will be Added When It Becomes Available.**

FEATURES: Chassis: T-6 aluminum anodized blue with fiber composite upper plate/
front brace
Radio: Traxxas TQ with high torque steering servo, trim and servo
reverse
Engine: Traxxas 2.5 racing engine with EZ-Start electric starter
Exhaust: Composite tuned pipe
Drive: Rear wheel with telescoping U-joint drive shafts
Body: Pre-painted, pre-cut polycarbonate body
Shocks: Four composite bodied oil-filled
Slipper Clutch: Adjustable
Suspension: 4-wheel independent
Transmission: Ball bearing equipped
Differential: Planetary gear with steel internal gears
Fuel Tank: 2.5oz (75cc) with flip-top lid and primer bulb
Brake: Composite disc type
Wheels: Chrome 2.2"
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to thei
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle

INCLUDES: Assembled Nitro Rustler with TRX-2.5 racing engine and glow plug,
EZ-Start electric starter, painted body with rear wing, decals,
TQ pistol grip radio, tuned pipe and instruction sheet

REQUIRES: 12 "AA" batteries, fuel, 6-cell battery, charger (for the battery)

SPECS:    Length:            17-1/4"   (438mm)
Front track:       12-1/2"   (318mm)
Rear track:        12-3/8"   (314mm)
Weight:            60 ounces (without radio)
Height:            6"        (152mm)
Wheelbase:         11.3"     (287mm)
Wheel diameter:    2.2"
Fuel capacity:     2.5 ounces (75cc)
Engine:            TRX 2.5 racing w/EZ Start System
Gear ratio:        Adjustable 8.43:1 to 12.64:1
Differential:      Planetary gear
Brake:             Disc
Chassis:           Double-decked  (bottom aluminum, top composite)
Spur gear:         72 black nylon tooth
Clutch bell:       20 steel tooth
Castor block front 30 degrees

COMMENTS  This vehicle comes equipped with bearings from the factory. If
individual replacements are needed the following sizes and
quantities are available:
Use: (8)  5x11mm for wheels       (DTXC1549 10pk)
(6)  5x11mm for transmission
(2)  5x11mm for clutch       (DTXC1547  2pk)
For complete bearing set use DTXC1326.

REPLACING EZ STARTER WITH STANDARD RECOIL STARTER
To convert the EZ starting to a standard "pull starter", purchase
part numbers TRAG5170, TRAP5211 one-way bearing, 4 3x8mm machine
screws, take out the three bolts on the EZ-Starter, clip the wires
on the EZ-Starter, and install recoil pullstart.

Available with the following radio channels and body colors;
TRAC84A1
TRAC84A2
TRAC84A4
TRAC84A5
TRAC84A6

ACCESSORIES					

THIS IS THE RTR TRAXXAS 1/10 SCALE NITRO RUSTLER STADIUM TRUCK.
FEATURES: OIL-FILLED SHOCKS, TRX 2.5 RACING ENGINE W/EZ-START, TUNED PIPE,
ADJUSTABLE SLIPPER CLUTCH, T-6 ALUMINUM CHASSIS
GLOW PLUG, AIR FILTER, PAINTED BODY AND TQ RADIO SYSTEM.
REQUIRES 12 "AA" BATTERIES, FUEL, 6-CELL STICK BATTERY & CHARGER.

 |  On-Road Nitro  |  Off-Road Nitro   |   On-Road Electric  |  Off-Road Electric  |  Search  |