TRA5207R   Traxxas   TRX 2.5R Racing Engine w/Recoil

TECH NOTES
               This is the Traxxas 2.5R Racing Engine with IPS
                  (Integrated Pilot Shaft) and Pull-Start.
         For use in all Traxxas vehicles that use the TRX 2.5 engine.

 ** This engine is a .15 engine. The 2.5 refers to a measurement of Cubic **
    Centimeter displacement compared to Cubic Inch displacement (.15).
                 60% More Power that the TRX Pro .15 engine!
  Loaded with advanced features such and the free flowing rear exhaust, the
  unique composite slide carb, and innovative porting only found on the most
                          exotic racing engines.

FEATURES: Slide carburetor provides less restrictive, straight through airflow
            for more power and better throttle response.
          PowerTune head is machined from aluminum which promotes even heat
           distribution for stable engine temperatures and rock-solid tuning
          New sleeve for improved engine efficiency and better power.
          Molded head protector prevents damage to the head and secures the
            glow plug wire.
          Ultra-low restriction air filter provides superior air flow and
            filtration for more power and a long engine life.
          Offset wrist pin further reduces piston slide loading for more
            even cylinder wear, and longer engine life.

INCLUDES: One 2.5 (0.15cu in) Engine with Pull Starter w/flywheel nut
          One 90 degree air filter (includes base for upright mounting)
          One 22 chapter Engine Set-up DVD
          One Owners manual/instruction booklet
          One bottle of air filter oil
          One Decal sheet
          One pre-installed glow plug

REQUIRES: Muffler (exhaust system) depending on vehicle
          Starting equipment
          Traxxas 10-20% "Top Fuel" nitro fuel. TRAP5010 or TRAP5020

UPGRADE KITS AVAILABLE
	T-MAXX PRO .15 TO TRX 2.5 TRA4900
	NITRO RUSTLER .15 TO TRX 2.5 TRA4400
	4-TECH PRO .15 TO TRX 2.5 TRA4800 
	
SPECS:    Displacement:                                   0.15 cu in (2.49cc)
          Crankshaft Thread:                                 5mm (.197")
          On-Center Mounting Holes, Front to Rear:          11mm (.433")
          On-Center Mounting Holes, Side to Side:         31.4mm (1.24")
          Back of engine(recoil)to front of drive washer: 73.2mm (2.88")
          Height:                                         97.3mm (3.83")
          Exhaust Port Diameter:                  inner -  9.9mm (.392")
                                                  outer - 13.0mm (.512")

COMMENTS: This engine shares the same mounting dimension as the OS 12-15 CV
           Series recoil engines.
          The TRX 2.5R (REVO) engine has a different cylinder head, crankcase,
           and sleeve than the TRX 2.5. All of the upgrade parts from the TRX
           2.5R will fit on the TRX2.5